American Hurricane Panels

Easy To Install

STEP 1
Measure window for sleeve locations and panel size. Cut panels 5/8” smaller both vertically and horizontally for best fit.

STEP 2
Mark the panel as to where you want each clamp making sure you have an equal number evenly spaced on each side. Tighten each clamp on the panel using a #2 Phillips screw driver.

STEP 3
Mark each location where clamp is going to be placed. Drill hole for sleeve using a 7/16 bit. Insert sleeve with hammer. We recommend drilling hole minimum 1 1/4” from face of building.

STEP 4
Replace the panel and clamps back into the opening. Adjust the position of the clamps to align the pin with the hole. Rotate the pin into its locked position.

TOOLS NEEDED FOR INSTALLATION

  • Hammer

  • Tape Measure

  • Hammer Drill

  • Phillips #2 Screw Driver

Complete Detailed Instructions Inside


Hurricane Window Protection | About The Clamp | Installation | Order Now | Contact Us

Copyright © 2007 American Hurricane Panels Inc. All Rights Reserved.
Site designed and managed by Profit Gate Inc.